HRN EN 10327:2008
Trake i limovi od niskougljičnih čelika za hladno oblikovanje s prevlakama nanesenim kontinuiranim vrućim uranjanjem -- Tehnički uvjeti isporuke (EN 10327:2004)
| Oznaka: | HRN EN 10327:2008 |
| Naslov (HR): | Trake i limovi od niskougljičnih čelika za hladno oblikovanje s prevlakama nanesenim kontinuiranim vrućim uranjanjem -- Tehnički uvjeti isporuke (EN 10327:2004) |
| Naslov (EN): | Continuously hot-dip coated strip and sheet of low carbon steels for cold forming -- Technical delivery conditions (EN 10327:2004) |
| Područje primjene (EN): | 1.1 This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ) and aluminium-silicon alloy (AS) (see Table 1) with thicknesses of 0,35 mm to 3,0 mm unless otherwise agreed (see 1.2). The thickness is the final thickness of the delivered product after coating. This European Standard applies to strip of all widths and to sheets cut from it (= 600 mm width) and cut lengths ( < 600 mm width). 1.2 If agreed at the time of enquiry and order, this European Standard may also be applied to continuously hot-dip coated flat products in thicknesses > 3,0 mm. In this case the mechanical property, adhesion of coating and surface condition requirements shall also be agreed at the time of enquiry and order. 1.3 The products covered by this European Standard are mainly used where cold formability and corrosion resistance are the most important factors. Corrosion resistance of the alloy is proportional to the coating thickness, hence to its mass (see also 7.3.2). 1.4 This European Standard is not applicable to: · continuously hot-dip coated structural steel flat products (see prEN 10326); · electrolytically zinc coated cold rolled steel flat products (see EN 10152); · continuously organic coated (coil coated) steel flat products (see EN 10169-1, ENV 10169-2 and EN 10169-3); · continuously hot-dip coated strip and sheet of steels with higher yield strength for cold forming (see EN 10292). |
| Izdanje: | 1 |
| ICS: | 77.140.50 Proizvodi i poluproizvodi od plosnatog čelika |
| Tehnički odbor/pododbor: | TO 503, Metalni materijali |
| Oznaka faze: | 95.99 - povlačenje HRN |
| Glasilo (rasprava): | HZN Glasilo 3/2008 () |
| Glasilo (objava): | HZN Glasilo 4/2008 () |
| Glasilo (povlačenje): | 4/2009 () |
| Način prihvaćanja: | pr - prihvaćanje strane norme u izvorniku |
| Cijena #1: | Cijena: 35,00 € | Jezik: en | Cjenovni razred: F | Broj stranica: 24 |
| Izvornik: | EN 10327:2004 |
| Zamjenjuje: | HRN EN 10142:2000 |
| Zamjenjena s: | HRN EN 10346:2009 |
Obrazac za naručivanje normativnih dokumenata i/ili publikacija (obrazac ob.025-2):